Wet Look High Gloss Sealer Enhances | Rejuvinates | with a Clear High Gloss

APPLICATION INSTRUCTIONS

FOLLOW THESE SIMPLE APPLICATION STEPS

Porous Vertical Surfaces
WET LOOK is supplied ready to use. DO NOT THIN. Mix thoroughly prior to use. Avoid application in windy weather. In hot weather, lightly dampen surfaces with clean fresh water to avoid premature or flash drying.   Most effective application method is with a hand pump garden sprayer or airless sprayer.  For smaller areas roller can be used.  Make sure not to leave any puddled areas on horizontal surfaces.

Start first coat application at the top of the wall. Apply flood coat with a 6î-8î rundown and back-roll material into surface voids. Apply second coat when the first coat is dry.

Vertical Concrete Surfaces
Material may be applied as soon as the forms are removed.  Surfaces shall be clean and free of form oils and release agents. Start first coat application at the top of the wall. Apply saturation coat and back-roll materials. Apply second coat when the first coat is dry.

Horizontal Concrete Surfaces
Apply 2 saturation coats to damp concrete to assist the curing and hardening process. Apply 1 saturation coat to existing concrete surfaces to dust proof surfaces. Remove
excess standing or ponding materials with a roller. Gloss will increase with the application of additional coats.

Brick
Apply 1 saturation coat with run-down and back-roll material. Apply second saturation coat when the first coat is dry.

Stucco/Plaster
May be applied to stucco or plaster during the curing process or when fully cured. Apply 1 saturation coat and backroll materials. Apply second coat when the first coat is dry.

Chalked Surfaces
Apply 1 coat to chalked surfaces. Allow material to dry and check surface for chalking. Apply a second coat to surfaces as needed to control remaining surface chalk.

Wood
Surfaces shall be clean and bare. Pre-treat knots with a small amount of material. Apply a minimum of 2 saturation coats to wood surfaces. Apply second coat when the first coat is dry.

Masonry and Concrete
All surfaces to be coated shall be structurally sound, clean and dry free of laitance, accumulated dirt and grime, efflorescence, lime run, form oils and release agents, grease, mud, excess mortar and mold and mildew, etc. Remove loose and peeling paint, excessive chalk and other contaminants from surfaces. Dry brushing is the preferred method for cleaning surfaces prior to material application. However, chemical, mechanical, abrasive or high-pressure water blasting may be used. Allow wet cleaned surfaces to dry for 2-3 days before application of materials.

EFIS and Other surfaces
Surfaces shall be structurally sound, clean and dry. Clean EFIS surfaces following manufacturerís recommendations.

PRECAUTIONS & LIMITATIONS
1. All surfaces to be coated should be clean of any dirt and grime, efflorescence, lime run, form oils and release agents, grease, mud, excess mortar, and mold and mildew, etc.
2. All cracks should be pointed or caulked. All voids, bee holes, masonry surface defects and openings such as conduits, pipes, drains, door frames, vents, air conditioner openings, electrical openings, control joints, or any dissimilar materials should be repaired using urethane or other approved patching.

STORAGE
Store materials in a well-protected area between 45° and 90°F. Avoid freezing temperatures, direct sunlight, and moisture. Keep away from heat sources.

Check out our customer projects using Wet Look High Gloss Acrylic Sealer!

Wet Look High Gloss Sealer Protects Wooden Deck