CLEAR-SEAL High Gloss Acrylic Urethane Sealer

APPLICATION INSTRUCTIONS

FOLLOW THESE SIMPLE APPLICATION STEPS

1.CLEAR-SEAL Acrylic Urethane Sealer should be applied using either brush, t-bar, lamb’s wool applicator, or most pump-up sprayers. We do not recommend using a roller to apply, as this may allow too much air, causing bubbles to stay in the film.

2.At time of application, moisture content of all surfaces should be 30%or less as measured with an electronic moisture meter.

3.Establish that air, surface and material temperatures are above 40°F (4.4°C) and at least 5°F above the dew point prior to painting. Do not apply at temperatures below 40°F or when temperatures are expected to drop below 40°F within 48 hours of application. Do not apply if rain, snow, or lower temperatures are expected within 48 hours. Do not apply if relative humidity is greater than 80%.

4.Allow at least 1 hour or until tack-free before applying a second coat.

5.Wait 24 hours before opening up to light to moderate traffic, and 72 hours before heavy traffic,

PRECAUTIONS & LIMITATIONS

1. All surfaces to be coated should be clean of any dirt and grime, efflorescence, lime run, form oils and release agents, grease, mud, excess mortar, and mold and mildew, etc.

2. All cracks should be pointed or caulked. All voids, bee holes, masonry surface defects and openings such as conduits, pipes, drains, door frames, vents, air conditioner openings, electrical openings, control joints, or any dissimilar materials should be repaired using urethane or other approved patching.

STORAGE

Store materials in a well-protected area between 45° and 90°F. Avoid freezing temperatures, direct sunlight, and moisture. Keep away from heat sources.