Gulf Coast Paint MFG. , Inc.
Showing 9–16 of 28 results
-
E1703 Epoxy Concrete Primer & Sealer | 100% Solids | Chemical & Abrasion Resistant | Easy to Apply | Low VOC
- Outstanding as a primer on concrete
- Good abrasion resistance
- Excellent adhesion to concrete surfaces
- Used as a clear sealer for concrete floors
- Non-toxic when cured
-
E1820 Clear Epoxy Coating | Metallic & Quartz Floor System | 40-50 Min Work Time | High Gloss | Abrasion Resistant
- Fast Cure Rate
- Excellent adhesion to concrete and masonry surfaces
- Designed as a clear epoxy for Metallic Pigments, Color Quartz and other decorative floors
- Long 40-50 Minute Working Time
- 100% solids formula eliminates any strong solvent odors
-
E1850 Epoxy Floor Coating | 100% Solids | High Gloss | Abrasion Resistant | Long 30-40 Min Work Time | High Build To 60 Mils DFT One Coat
- Easy to Use With Long to 40 Min Work Time
- 100% solids
- Extremely high gloss, tile-like finish
- Outstanding wear and abrasion resistance
- Good resistance to blushing
-
E1875 Epoxy Resin | Chemical Resistance | 100% Solids
- Excellent resistance to acids, alkalis, salts, most industrial chemicals and many solvents
- For Use in tough corrosive chemical environments including 70% Sulfuric Acid, 37% HCL and 50% Sodium Hydroxide
- Extremely tough with high wearing properties
- Excellent abrasion and impact resistance
- Good adhesion to concrete
-
E1900/E1901 Polyaspartic Clear Topcoat | 40-50 Min Work Time | Quick Cure | High Solids | Apply 40°F – 100°F | Chemical Abrasion Impact Resistant
- Excellent Clear Top coat for decorative flake and quartz granule systems and solid color epoxy coatings.
- Fast set back in service as quick as 5 hours for foot traffic at 75F
- Resistant to hot tire pick up.
- Highly resistant to chemical, abrasion and impact
- Meets USDA requirements for incidental food contact
-
E2.8 Poly-Chemcure Primer | Fast Recoat | Low-Temp | OEM/Steel Fabricator
- High performance primer can be prepared on carbon steel, galvanized steel and aluminum
- Recoating in 90 minutes is possible for maximum productivity
- No induction time and longer pot life will improve productivity
- A smooth, sandable primer at 3 mils DFT over abrasive blasted or power tool cleaned substrate is needed for additional corrosion resistance
- Application by brush and roller, in addition to spraying, may be necessary
-
E211 Epoxy Primer & Sealer
- Good chemical, abrasion and impact resistance
- Outstanding adhesion and "wetting out" properties
- Very low permeability-tight sealed film
- Used as a primer and/or finish coat
- USDA Approvable
-
E275 High Build Polyamide Epoxy Mastic | Chemical Resistant | Excellent Adhesion to Steel
- Excellent adhesion to steel
- Meets USDA Requirements
- A high build primer or finish coat
- Excellent against "undercutting"
- Can be applied up to 12 mils DFT