Aluminum Archives

E1500HN Novolac Epoxy | Superior Steel & Concrete Chemical Horizontal Protection | Secondary Co...

$340.00

Excellent resistance to acids, alkalis, salts, most industrial chemicals and many solvents
For Use in tough corrosive chemical environments including 98% Sulfuric Acid, 37% HCL and 70% Sodium Hydroxide
Great horizontal chemical protection for Secondary Containment for both steel and concrete surfaces
Thin film self leveling to 40 mils DFT one coat
Extremely tough with high wearing properties
Excellent abrasion resistance and impact resistance
Meets USDA requirements

Select options

From: $95.00

High solids DTM (direct-to-metal) chemical resistant steel primer or finish coat to steel and concrete
Self priming to steel including tight rust
Apply Vertical Surfaces to 8 mils DFT Steel & Concrete
Great primer for use with our E1500HN (horizontal) and E555VN (vertical) Novolac Chemical Resistant Epoxies
USDA Approved
Tight film, low permeability.
Exceptional adhesion Exceeds 500 psi
Excellent impact resistance 90 in lb
Excellent abrasion resistance CS 17 Wheel, 1000 cycles, 1000 g Load 21 mg loss
Excellent against rust “undercutting”
Easy to apply brush, roll and spray
Low temp cure version to 25°F
Available 13 colors

Select options

From: $125.00

Self Priming on steel
Excellent primary containment coating for internal tank linings (when part of specified system)
Excellent secondary containment coating
Performs well over epoxy mortars and properly primed concrete surfaces
Can be applied on damp surfaces
Excellent chemical resistance to acids, caustics, solvents
Outstanding impact and abrasion resistance.
Exceptional adhesion Exceeds 700 psi
Excellent flexibility pass 7/8" mandrel 180º Bend
Apply Vertical Surfaces to 15 mils one coat
Meets USDA requirements.
Low temp cure version to 25°F
Low VOC 72 grams/Liter

Select options

$142.00

Excellent resistance to acids, alkalis, salts, most industrial chemicals and many solvents
For Use in tough corrosive chemical environments including 98% Sulfuric Acid, 37% HCL and 70% Sodium Hydroxide
Vertical application to 10 mils DFT.
Great for Secondary Containment for both steel and concrete surfaces
Use as Primary Containment and Tank Linings when used as part of specified system
Excellent abrasion resistance with ceramic filler
Excellent in battery storage room areas.
Meets USDA requirements
May be applied in cold, damp conditions to 45°F with curing down to 35°F

Select options

Out of stock

Promotes adhesion and bonding on hard to paint surfaces
Glazed Tile, Plastic, Glass, Fiberglass, Glossy Surfaces, Kitchen Cabinets
Tightly bonds to slick and glossy surfaces
Assures uniform appearance of topcoats
One coat application
Fast dry
Use as bonding primer with Cool Coat Thermal Barrier Paint
Topcoat With Hi-Performance coatings such as epoxy, polyaspartic, urethanes, lacquers and both oil and water based acrylics

Out of stock

Rust-inhibitive for steel, aluminum, galvanized steel
Excellent corrosion-resistant primer
Use with all acrylic, alkyd, urethane, epoxy topcoats – both solvent & water base
Early moisture resistant
Quick dry to recoat time for faster project turnaround
Low temperature application down to 40F
Use as bonding primer with Cool Coat Thermal Barrier Paint
Available in red-oxide, gray and off-white
Acceptable for use in USDA-inspected facilities
Low VOC, water base, complies with SCAQMD & CARB