EXPERT Clean & Bright Wood Stripper & Heavy Duty Wood Cleaner | Stain Remover | Removes and Cleans Extreme Organic Growth | Restores Natural Wood Beauty | No Bleach Formula

COVERAGE RATE

8oz of EXPERT Clean & Bright Wood Stripper will make 1 gallon of cleaning solution and cover approximately  8oz of EXPERT Clean & Bright Wood Cleaner will make 1 gallon of cleaning solution and cover approximately 150 to 250 sq. ft.  depending on surface and method of application.

APPLICATION INSTRUCTIONS FOLLOW THESE SIMPLE APPLICATION STEPS

Mixing Instructions

Always wear heavy-duty rubber gloves, NIOSH approved respirator and PPE when working with EXPERT Clean & Bright Wood Cleaner, or any other EXPERT Clean & Bright products. Wood Strippers can cause chemical burns if in contact with skin, eyes or lungs.

Mix 4 oz to 8 oz of Wood Stripper with each gallon of warm water and stir thoroughly until powder is mostly dissolved. Mix in a separate 5-gallon pail before transferring into a pump sprayer. This avoids clogging the sprayer. Use Stripper solution within 6 hours of mixing. Wood Stripper mixed solution is Red in color for ease of identification.

Mix Rates

• Light Strip: mix 1/4 cup per gallon of water
• Medium Strip: mix 1/2 cup per gallon of water
• Heavy Strip: mix 1 cup per gallon of water

Application

Strippers must be kept wet or they will not work, a light mist every few minutes will do.  Pre wet the surface with water before application. Apply EXPERT Clean & Bright Wood Stripper solution with a sprayer, brush, or car wash brush, working on small areas (100-200 sq. ft.) at a time.

If applying stripper on vertical surfaces using a sprayer, work on small areas at a time, starting at the bottom, and working your way up.

If needed, scrub thoroughly with a hard, short, bristled broom, or brush. Be sure to keep the area wet with additional solution or mist from a water hose and allow the wood Stripper to sit for approximately 5 to 45 minutes or until the desired result is achieved. Be sure to keep the stripping surface wet with more solution or water mist from a hose.

Rinse

Rinse thoroughly with water from a hose or pressure washer using lowest effective pressure, to clean without damaging the wood.  For extreme build up of dirt, or organic growth use either a power washer, or a hard bristled brush. While using a power washer, use only the minimum effective amount of pressure to achieve the desired result.  Particular care should be taken in order to not damage the wood, power wash using a pendulum motion the full length of each board.  Do not start and stop as scarring or gouging of wood can occur.  **Paint and stain chips may stick to and can dry on other painted surfaces, caution must be used to completely rinse away all of the old finish from all surrounding surfaces

Neutralize

After stripping is complete, immediately neutralize and brighten the wood using EXPERT Clean & Bright Wood Brightener. Let EXPERT Wood Brightener sit for 5 to 15 minutes ensuring the entire surface has been properly neutralized and rinsed thoroughly. A color change will be evident when properly brightened, this will open wood grain and prevent poor stain penetration.

Important

After Brightener is applied, rinse wood’s entire surface for 10 to 15 minutes, and rinse all nearby surfaces including siding, windows, and foliage.

Allow wood surfaces to dry 48 to 72 hours (or longer) before applying EXPERT Stain & Seal wood stains. Stains must be applied when wood is dried to 13% moisture content or less.

Clean-Up

Clean tools and equipment immediately after each use with soap and water.

Additional Instructions

• Strippers must be kept wet or they will not work, a light mist every few minutes will do.
• Test on a small, inconspicuous area of the wood to ensure proper wood care.
• Always wet plants, shrubs, and other surrounding vegetation before and after use.
• Always brighten the wood after using this cleaner using Stain & Seal Wood Brightener

WARNING

Extreme caution should be taken when using strippers. They will burn skin, remove paint form houses, and kill plants, grass and pets.

• Keep out of reach of children. Exposure to sodium metasilicate could cause irritation to the eyes, skin, or lungs.
• If contact occurs, rinse immediately with water for 15 minutes. If irritation continues, seek immediate medical attention.
• Do not ingest.
• Always wear personal protective equipment when using this product.
• DO NOT MIX WITH OTHER CHEMICALS.

NOTICE TO BUYER: DISCLAIMER OF WARRANTIES AND LIMITATIONS ON OUR LIABILITY We warrant that our products are manufactured to strict quality assurance specifications and that the information supplied by us is accurate to the best of our knowledge. Such information supplied about our products is not a representation or a warranty. It is supplied on the condition that you shall make your own tests to determine the suitability of our product for your particular purpose. Any use or application other than recommended herein is the sole responsibility of the user. Listed physical properties are typical and should not be construed as specifications. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, REGARDING SUCH OTHER INFORMATION, THE DATA ON WHICH IT IS BASED, OR THE RESULTS YOU WILL OBTAIN FROM ITS USE. N0 WARRANTY IS MADE, EXPRESSED OR IMPLIED, THAT OUR PRODUCT SHALL BE MERCHANTABLE OR THAT OUR PRODUCT SHALL BE FIT FOR ANY PARTICULAR PURPOSE. NO WARRANTY IS MADE THAT THE USE OF SUCH INFORMATION OR OUR PRODUCT WILL NOT INFRINGE UPON ANY PATENT. We shall have no liability for incidental or consequential damages, direct or indirect. Our liability is limited to the net selling price of our product or the replacement of our product, at our option. Acceptance of delivery of our product means that you have accepted the terms of this warranty whether or not purchase orders or other documents state terms that vary from this warranty. No representative is authorized to make any representation or warranty or assume any other liability on our behalf with any sale of our products. Our products contain chemicals that may CAUSE SERIOUS PHYSICAL INJURY. BEFORE USING, READ THE MATERIAL SAFETY DATA SHEET AND FOLLOW ALL PRECAUTIONS TO PREVENT BODILY HARM.