EXPERT Clean & Bright Eco Cleaner | Step 1 (LIGHT)| Multi-Purpose Wood Cleaner & Stain Remover| Removes Organic Growth | Oxygenated Wood Bleach

COVERAGE RATE

4oz to 8oz of EXPERT Clean & Bright Eco Cleaner will make 1 gallon of cleaning solution after adding water and cover approximately 150 to 250 sq. ft. depending on surface and method of application.

APPLICATION INSTRUCTIONS FOLLOW THESE SIMPLE APPLICATION STEPS:  Easy-to-Use & Clean-Up.

Read through all the step-by-step instructions prior to using EXPERT®™ Clean & Bright Eco Cleaner.

MIXING: Always wear heavy-duty rubber gloves, niosh approved respirator and PPE when working with EXPERT Clean & Bright Eco Cleaner, or any other EXPERT Clean & Bright products.

Mix 4oz to 8oz of Eco Cleaner with each gallon of warm water and stir thoroughly until powder is mostly dissolved. For larger projects 8 pounds of powder in a 1 gallon container makes 16 gallons of liquid cleaner.  Mix in a separate 5-gallon pail before transferring into a pump sprayer. This avoids clogging the sprayer. Use Cleaner solution within 4 hours of mixing.  Eco Cleaner mixed solution is Green in color for ease of identification.

APPLICATION: Pre wet the surface with water before application. Apply EXPERT Clean & Bright Eco Cleaner solution with a sprayer, brush, or car wash brush, working on small areas (100-200 sq. ft.) at a time.

If applying cleaner on vertical surfaces using a sprayer, work on small areas at a time, starting at the bottom, and working your way up.

If needed, scrub thoroughly with a hard, short, bristled broom, or brush. Be sure to keep the area wet with additional solution or mist from a water hose and allow the eco cleaner to sit for approximately 5 to 20 minutes or until the desired result is achieved.

RINSE: Rinse thoroughly with water from a hose or pressure washer using lowest effective pressure, to clean without damaging the wood.  For extreme build up of dirt, or organic growth use either a power washer, or a hard bristled brush. While using a power washer, use only the minimum effective amount of pressure to achieve the desired result.  Particular care should be taken in order to not damage the wood, power wash using a pendulum motion the full length of each board.  Do not start and stop as scarring or gouging of wood can occur.

NEUTRALIZE: After cleaning is complete, immediately neutralize and brighten the wood using EXPERT Clean & Bright Wood Brightener. Let EXPERT Wood Brightener sit for 5 to 15 minutes ensuring the entire surface has been properly neutralized and rinsed thoroughly. A color change will be evident when properly brightened, this will open wood grain and prevent poor stain penetration.

IMPORTANT: After Brightener is applied, rinse wood’s entire surface for 10 to 15 minutes, and rinse all nearby surfaces including siding, windows, and foliage.

Allow wood surfaces to dry 48 to 72 hours (or longer) before applying EXPERT Stain & Seal wood stains. Stains must be applied when wood is dried to 13% moisture content or less.

Clean-up: Clean tools and equipment immediately after each use with soap and water.

WARNING

• Keep out of reach of children. Exposure to sodium metasilicate could cause irritation to the eyes, skin, or lungs.
• If contact occurs, rinse immediately with water for 15 minutes. If irritation continues, seek immediate medical attention.
• Do not ingest.
• Always wear personal protective equipment when using this product.
• DO NOT MIX WITH OTHER CHEMICALS.

NOTICE TO BUYER: DISCLAIMER OF WARRANTIES AND LIMITATIONS ON OUR LIABILITY We warrant that our products are manufactured to strict quality assurance specifications and that the information supplied by us is accurate to the best of our knowledge. Such information supplied about our products is not a representation or a warranty. It is supplied on the condition that you shall make your own tests to determine the suitability of our product for your particular purpose. Any use or application other than recommended herein is the sole responsibility of the user. Listed physical properties are typical and should not be construed as specifications. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, REGARDING SUCH OTHER INFORMATION, THE DATA ON WHICH IT IS BASED, OR THE RESULTS YOU WILL OBTAIN FROM ITS USE. N0 WARRANTY IS MADE, EXPRESSED OR IMPLIED, THAT OUR PRODUCT SHALL BE MERCHANTABLE OR THAT OUR PRODUCT SHALL BE FIT FOR ANY PARTICULAR PURPOSE. NO WARRANTY IS MADE THAT THE USE OF SUCH INFORMATION OR OUR PRODUCT WILL NOT INFRINGE UPON ANY PATENT. We shall have no liability for incidental or consequential damages, direct or indirect. Our liability is limited to the net selling price of our product or the replacement of our product, at our option. Acceptance of delivery of our product means that you have accepted the terms of this warranty whether or not purchase orders or other documents state terms that vary from this warranty. No representative is authorized to make any representation or warranty or assume any other liability on our behalf with any sale of our products. Our products contain chemicals that may CAUSE SERIOUS PHYSICAL INJURY. BEFORE USING, READ THE MATERIAL SAFETY DATA SHEET AND FOLLOW ALL PRECAUTIONS TO PREVENT BODILY HARM.

What does EXPERT Clean & Bright Eco Cleaner remove?

EXPERT Clean & Bright Eco Cleaner removes surface dirt, grime, and stains caused by organic growth such as mold, mildew, and algae from exterior wood surfaces. It also helps remove light weathering and gray discoloration caused by UV exposure to restore the natural appearance of wood.

What surfaces can Eco Cleaner be used on?

Eco Cleaner can be used on a wide range of exterior surfaces including:

• Wood decks

• Wood fences

• Wood siding

• Outdoor furniture

• Boardwalks and docks

• Pergolas and log homes

The formula is also safe for use on vinyl and composite materials when properly rinsed.

Does Eco Cleaner remove mold, mildew, and algae?

Yes. Eco Cleaner is formulated to remove stains and buildup caused by mold, mildew, and algae. The oxygenated cleaning formula breaks down organic growth and helps restore the natural color of exterior wood surfaces.

Will Eco Cleaner remove old deck stain or paint?

Eco Cleaner is designed for light cleaning and maintenance, so it removes dirt, grime, and light organic staining but is not intended to remove intact stain, paint, or clear finishes.

If your deck has an existing stain or sealer that needs to be removed, a stronger wood stripper should be used instead.

Is Eco Cleaner bleach-based?

No. Eco Cleaner uses an oxygenated cleaning formula made with sodium metasilicate and sodium percarbonate rather than chlorine bleach. This helps clean wood surfaces while being gentler on wood fibers and surrounding landscaping.

Is Eco Cleaner safe for plants, grass, and pets?

When used according to instructions, Eco Cleaner is designed to be environmentally friendly and safe for use around most landscaping. It is recommended to pre-wet plants and rinse nearby surfaces after cleaning as an added precaution.

How much area does Eco Cleaner cover?

Coverage typically ranges from 150–250 square feet per gallon of mixed solution, depending on the condition of the surface and the application method used.

How do you mix Eco Cleaner?

Eco Cleaner is a powdered concentrate that is mixed with warm water before use.

Typical dilution rates are:

• 4–8 oz of powder per gallon of water for general cleaning

• Larger containers can be mixed at higher volumes for bigger projects

The mixed solution should be used within several hours for best results.

How do you apply Eco Cleaner to wood?

Basic application steps include:

1. Pre-wet the wood surface with water.

2. Apply the Eco Cleaner solution using a pump sprayer or brush.

3. Allow the cleaner to dwell for 5–20 minutes while keeping the surface wet.

4. Scrub lightly if needed.

5. Rinse thoroughly with water or low-pressure washing.

After cleaning, apply a wood brightener to neutralize the wood before staining.

Do I need to brighten the wood after cleaning?

Yes. After using an alkaline wood cleaner, it is recommended to apply a wood brightener to neutralize the surface and restore the wood’s natural pH and color. This step helps ensure proper stain penetration.

How long should wood dry before staining?

After cleaning and brightening, wood should typically dry 48–72 hours before applying stain or sealer. The moisture content of the wood should generally be below 13% before staining.

What is the difference between the Step 1 wood cleaning products in the EXPERT Wood Restoration System?

The EXPERT Step 1 Clean process offers four different wood cleaning products designed to remove dirt, grime, organic growth, and old stains from exterior wood surfaces. The main difference between them is cleaning strength and the type of buildup they are designed to remove.

Eco Cleaner – Light Cleaning
Eco Cleaner is designed for routine maintenance cleaning. It removes light dirt, mild organic growth, and surface grime from wood decks, fences, and siding that are still in good condition.

Wood Cleaner – Mild Cleaning
Wood Cleaner is ideal for moderately dirty wood. It removes dirt, mildew, algae, and light staining from weathered wood surfaces that need more than a simple maintenance wash.

Wood Stripper – Heavy Cleaning
Wood Stripper is formulated to remove old wood stains, weathered coatings, gray wood fibers, and heavy organic buildup. It is typically used when preparing decks, fences, or siding for refinishing with a new stain or sealer.

Wood Stripper Booster – Extra Heavy Cleaning
Wood Stripper Booster is an additive that increases the strength of the wood stripper. It is used when dealing with very stubborn coatings, multiple layers of stain, or difficult water-based finishes that require additional stripping power.

Using the correct Step 1 cleaner ensures the wood is properly prepared before brightening and staining.

Do I need to clean my deck before staining?

Yes. Cleaning wood before staining removes dirt, mold, mildew, and contaminants that can prevent stain from penetrating the wood. Proper surface preparation helps stains apply more evenly and last longer.