Off White
Showing 1–8 of 17 results
-
E100V Vertical Wall High Build Epoxy Coating | Underwater Concrete | P
- No sagging on vertical walls up to 12 mils per coat
- Good chemical and abrasion resistance
- Works well on underwater concrete decorative surfaces including pools and water features
- Long 45 - 90 min pot life
- Outstanding adhesion 475 psi @elcometer
-
E1015V Vertical Wall Epoxy Coating & Primer to 8 Mils No Sag | 11 Colo
- No sagging on vertical walls up to 8 mils per coat (4 mils DFT)
- Good for priming or coating concrete, wood or masonry.
- Good chemical and abrasion resistance
- Long 1 - 1.5 hour pot life
- Excellent adhesion 425 psi @elcometer
-
E1016 Anti-Slip Epoxy Concrete Floor Coating – 3 Gal Kit | 20 Colors | Tennis Court Like Surface
- Adds a slip resistant finish to concrete floors
- Good for use on surfaces subject to bare foot traffic
- Long 1 - 1.5 hour pot life
- Excellent adhesion
- Good chemical and abrasion resistance
-
E139FL Flexible Epoxy Primer & Floor Coating | 60% Elongation | 100% Solids | Indoor & Outdoor
- Exceptionally flexible epoxy with 60% elongation
- High Build up to 50 mils thick per coat
- 100% Solids Commercial Epoxy
- Excellent Adhesion 450 psi
- Tough Abrasion resistant Only 6 mg loss (Tabor test) and 160 inch lbs Gardner variable impact test
-
E144 Epoxy Primer & Base Coat | Concrete Wood metal | Satin Finish | Flexible | 20 Colors | Solvent Base | Low Temp 40F
- Commercial Grade Epoxy Primer & Coating
- Versatile Works on Concrete, Wood, Steel
- Helps reduce problems from concrete outgassing (air bubbles)
- Long POT Life 3+ hours Means Easy Dip and Roll Application
- Apply low temp to 40F
-
E145 Polyamide Epoxy Block Filler | Concrete Block & Masonry Vertical Walls | High Build to 11.5 Mils DFT One Coat
- Excellent Adhesion to Vertical Block and Masonry Surfaces
- Excellent filling properties provide ideal "hold out"
- High Build Apply to 11.5 mils DFT (dry film thickness) One Coat
- Basecoat for high performing coating systems
- Hard film with high impact
-
E322HW High-Gloss Aliphatic Urethane Abrasion & Chemical Resistant Low
- Outstanding durability with impact resistance of 160 in lb (Gardner Impact test)
- Excellent abrasion resistance Only 22 mg loss (Tabor Abrasion test) Reduced to 10 mg loss using our High Wear 325 additive
- Cold temperature application down to 45F
- Excellent Chemical Resistance
- Aliphatic, UV Stable and will not yellow
-
E322SG Semi-Gloss Aliphatic Urethane Abrasion & Chemical Resistant Low
- Outstanding durability with impact resistance of 160 in lb (Gardner Impact test)
- Excellent abrasion resistance Only 24 mg loss (Tabor Abrasion test) Reduced to 12 mg loss using our High Wear 325 additive
- Cold temperature application down to 45F
- Excellent Chemical Resistance
- Aliphatic, UV Stable and will not yellow