Shingle-Lok Asphalt Shingle Coating | Weather Protection | Resists Cracking & Chipping | 7 Colors

APPLICATION INSTRUCTIONS

FOLLOW THESE SIMPLE APPLICATION STEPS

**Before Beginning ensure all surfaces be clean and dry with no dirt, debris, algae, mildew or other contaminants. These satins, along with others, will prevent proper penetration of Shingle-Lok to sufficiently Seal**

1.  Stir thoroughly until uniformly blended. Avoid excessive mixing to prevent air entrapment. Thinning is not recommended

2. Spray, Brush or Roll saturating entire surface. Drying time to recoat at 70 F. 50% RH: 2 hours

3. Clean equipment with water or water and detergent immediately after use

PRECAUTIONS & LIMITATIONS
1. All surfaces to be coated should be clean of any dirt and grime, efflorescence, lime run, form oils and release agents, grease, mud, excess mortar, and mold and mildew, etc.

2. All cracks should be pointed or caulked. All voids, bee holes, masonry surface defects and openings such as conduits, pipes, drains, door frames, vents, air conditioner openings, electrical openings, control joints, or any dissimilar materials should be repaired using urethane or other approved patching.

3. Do not apply to surfaces if moisture content is greater than 25% as measured with an electronic moisture meter

STORAGE
Store materials in a well-protected area between 45° and 90°F. Avoid freezing temperatures, direct sunlight, and moisture. Keep away from heat sources.