mil spec Archives

E15M Epoxy Mastic Steel Primer DTM & Concrete Coating | Chemical Resistant | Low Temp 25F

From: $95.00

High solids DTM (direct-to-metal) chemical resistant steel primer or finish coat to steel and concrete
Self priming to steel including tight rust
Apply Vertical Surfaces to 8 mils DFT Steel & Concrete
Great primer for use with our E1500HN (horizontal) and E555VN (vertical) Novolac Chemical Resistant Epoxies
USDA Approved
Tight film, low permeability.
Exceptional adhesion Exceeds 500 psi
Excellent impact resistance 90 in lb
Excellent abrasion resistance CS 17 Wheel, 1000 cycles, 1000 g Load 21 mg loss
Excellent against rust “undercutting”
Easy to apply brush, roll and spray
Low temp cure version to 25°F
Available 13 colors

Select options

From: $125.00

Self Priming on steel
Excellent primary containment coating for internal tank linings (when part of specified system)
Excellent secondary containment coating
Performs well over epoxy mortars and properly primed concrete surfaces
Can be applied on damp surfaces
Excellent chemical resistance to acids, caustics, solvents
Outstanding impact and abrasion resistance.
Exceptional adhesion Exceeds 700 psi
Excellent flexibility pass 7/8" mandrel 180º Bend
Apply Vertical Surfaces to 15 mils one coat
Meets USDA requirements.
Low temp cure version to 25°F
Low VOC 72 grams/Liter

Select options

From: $107.00

Heavy duty non-skid resistance for concrete & steel
Available in regular cure and cold temp formula to 25°F
Designed for wet areas
Meets ADA and OSHA requirements for safe co-efficient of friction (COF) when properly applied
Meets Navy Military Specification Mil-PRF-24667B for Non-Skid Deck Coatings
Excellent adhesion, abrasion and impact resistance
Resistant to grease, oil, salt water, alcohol, detergent, gasoline, hydraulic fluid
Excellent coating for Diamond Plate
Easy to apply, ready to use non-skid coating
Comes in 4 colors

Select options