Anti-Static epoxy floor Coating
Showing all 5 results
-
GroundWorx Basics (SF) ESD Static Conductive Epoxy Floor Coating | Water Based | ANSI/ESD S20.20-2014
- Water - based epoxy, matte finish
- Conductive range 2.5 x 104 - 3.5 x 107 ohms
- System Resistance (w/ ESD Footware) < 3.5 x 107 (fully compliant) ANSI/ESD STM 97.1
- Great low cost solution for concrete, wood, VCT Tile floors
- Extended working time - POT life 40+ minutes
-
GroundWorx Basics (SF) ESD Static Dissipative Epoxy Floor Coating | Water Based | ANSI/ESD S20.20-2014
- Water - based epoxy, matte finish
- Static Dissipative 10e6 - 10e9 ohms
- Great low cost solution for concrete, wood, VCT Tile floors
- Extended working time - 40+ minutes
- Quick turnaround - Light traffic 12 hours after application
-
GroundWorx Ultra (HB-97.2) ESD Static Conductive Epoxy Basecoat 100% Solids | Forklift Traffic | ANSI/ESD S20.20-2014
- Static dissipative or conductive high build epoxy electrical protection when used with the GroundWorx Ultra ESD Urethane Topcoat, which comes in either dissipative >1.0 x 10e6 ohms or conductive <1.0 x 10e6 ohms electrical resistance, limiting Static Charge Generation to <15 volts
- Great for high traffic, high wear commercial & industrial applications as high build 14 mil ESD system at <$4.00/sq' material cost
- Great for high traffic, high wear commercial & industrial applications
- Use on Concrete, Wood and old VCT surfaces
- Moisture tolerant primer
-
GroundWorx Ultra (HB-97.2) ESD Urethane Top Coat | Static Dissipative or Conductive | ANSI S20.20-2014
- Optional Static conductive <1.0 x 10e6 ohms or Dissipative >1.0 x 10e6 and <1.0 x 10e9 ohms high performance electrical protection, limiting Static Charge Generation to <15 volts
- Great for high traffic (forklift & pallet jack), high wear commercial & industrial applications with high build 14 mil system
- Conforms to ESDA, ANSI standard S20.20-2014 when used with the GroundWorx Ultra ESD Epoxy Primer
- Use on Concrete, Wood and old VCT surfaces
- Tough surface: impact resistance 140 psi and tabor abrasion test 25 mg loss
-
GroundWorx Ultra Elevated Moisture Epoxy Primer | For Use In GroundWorx Ultra Epoxy Systems | Zero VOC | Recoat in 5 Hours
- Protects ESD Coatings System from moisture related issues (withstands up to 8lbs of moisture vapor pressure)
- Apply when relative humidity is up to 95%
- Significantly reduce chance of concrete outgassing
- Great for high traffic (forklift & pallet jack), high wear commercial & industrial applications
- Conforms to ESDA, ANSI standard S20.20-2014 when used with the GroundWorx Ultra ESD Epoxy Basecoat and the companion Ultra Urethane Toopcoat