GasPruf E132 Reinforced Epoxy Coating

Recommend Application Thickness is 6 mils on flat surface.

40 sq ft / gal @ 40 mils rec. U/W application rate.

CURE SCHEDULE

APPLICATION TEMPERATURE: 45- 110 degrees F

Product Use Instructions 

SURFACE PREPARATION 

Remove loose corrosion products using suitable abrasive techniques to leave a coarse, sound surface. Suitable preparation techniques would include needle-scaling with sharp needles or

abrasive discing. Application above water requires similar preparation and would include high pressure water blasting or dry abrasive blasting to yield a firm, granular surface free of loose contamination.

MIXING PROCEDURES 

GasPruf E132 is supplied either in 2 gallon or 4 gallon kits of 2x1 or 2x2 gallon containers respectively each of polymer base and curing agent. These components are formulated in contrasting

colors of Red base and Green curing agent to yield a dark brown color on mixing. Visible streaks of either Red or Green seen during the course of mixing indicate "hotspots" unmixed components which will never cure.

For small repairs remove equal quantities of base and curing agent from their cans and place them side-by-side on a surface of plastic, fiberboard etc. Mixing is easily accomplished by folding the components into each other using a spatula such as a tongue depressor or paint mixing stick. Once mixing begins there will be about 10 minutes of working time available at 80°F. This time may be extended by keeping the components and mixture cool, avoid leaving mixed material on a hot deck. Storing the unmixed components in an air-conditioned space prior to using will ensure that the mixture starts out cool in order to further extend its useful life.

APPLICATION 

) ABOVE WATER: Apply using an appropriate tool such as a spreader or short, stiff brush if the surface is especially rough

2) UNDER GASOLINE OR DIESEL FUEL: If the surface is safely accessible to personnel simply apply by spreader or brush.

CURING BEFORE SERVICE 

Gaspruf E132 may be immersed in gasoline, diesel fuel, fresh or salt water immediately after application. It will cure to a hard film within about 4 hours and is suitable for traffic after this time. Allow at least a day at 77F before subjecting to aggressive service from industrial solvents and similar materials.

Safety: This is a hazardous material if misused. Read and understand the Safety Data Sheets (SDS's) before use

Warranty Disclaimer: The technical data given herein has been compiled for your help and guidance. It is based upon our experience and knowledge however, as we have no control over the use to which this information is put, no warranty, express or implied, is intended or given. We assume no responsibility whatsoever for coverage, performance, or damages, including injuries resulting from use of this information or products recommended herein.