EE-70 Amine Cured 100% Solids Spray Apply Epoxy | Secondary Containment | NSF 61 Potable Water | USDA | Chemical Resistant | Tanks | Floors | Pipes

Chemical Resistance

1. Excellent: Suitable for Immersion 2. Very Good: Suitable for Immersion 3. Good: Suitable for Secondary Containment 4. Fair: Spill/Splash

Alkalies

Solvents

ACIDS

Product Use Instructions 

SURFACE PREPARATION

Steel surfaces are to be abrasive blasted with chloride free abrasive. Exterior applications to SSPC SP-10 Near White metal finish. Immersion applications to SSPC SP-6 White metal. Grind flat all burrs, weld seams, radius sharp edges. Fresh blasted surfaces to be primed with Arcor EE-31 or Arcor EE-50.

Concrete Surfaces: Not recommended for hand or roller application. Apply by heated plural or airless spray only. Concrete surfaces should be degreased if oil and grease contamination is present. Degreased surface shall be high pressure washed, acid etched and high pressure washed again so surface is clean and free of all grease, oils and surface laitance. Existing coatings should be abrasive blasted to clean concrete.

MIXING:

Thoroughly mix Activator into Base with mixing stick or drill with low speed mixing blade. Mix by Volume 1.3 parts Base to 1 part Activator or by Weight 100gm Base to 67.5 gm Activator.

THINNING: Never Thin

APPLICATION:

By Brush use medium to stiff bristle of sufficient quality that bristles do not pull out and stick in coating. Trim or tape to <1″ nap.

Roller use good quality 1/8″ nap.

Plural Spray use .023-.032 tip, 3,000-3,500 PSI, Heat to 130F Base, 110F Activator

Airless Spray Not Recommended

Conventional Spray Not Recommended

All spray equipment should employ traps to prevent water and oil from contaminating coating and screens to prevent particulate contamination.

APPLICATION TEMPERATURE:

Material: Keep between 55-95F (13 to 35C). Substrate: Keep between 45 to 105F. The difference in temperature of the substrate and the coating should never exceed 10F.

OVERCOAT / CURE TIME:

By Brush or Roller recoat between 6 and 8 hours at 72F. When spraying recoat between 5 and 8 hours. Full cure before immersion 3 days at 77F. Force Cure: 12 hours at 150F.

Manufacturer, Novolac Epoxy Technologies Inc., makes no warranty either expressed or implied including warranties of merchantability or fitness for a particular purpose for this product. Under no circumstances will the manufacturer be liable for incidental, consequential or other damages, breach of warranty, strict liability, or any other theory arising out of use of this product. The information and or recommendations contained herein are based on standard Product and are proprietary and furnished solely for the use of our customers. This information is provided in good faith and believed to be true and accurate as of the date/version of this document. As the manufacturer has no control over the use conditions or application process of the parties using this product, the manufacturer cannot accept responsibility for loss, injury or other damages resulting from the use of the Product or this or any other information provided by the manufacturer. Therefore, no guarantees of any kind, expressed or implied, are made by the manufacturer, Novolac Epoxy Technologies Inc., regarding this, or any, product manufactured by them or any contracted or licensed manufacturer. ARCOR® epoxy products do not provide structural integrity or improvement. They are only used to provide protection from corrosion, wear, abrasion and chemical attack on a given substrate and only to the extent provided for in the Data Sheets, Technical Data Sheets, Safety Data Sheets and any other information as supplied in writing directly from manufacturers technical support.