Tan
Showing 1–8 of 25 results
-
1007 Polyurea Coating Fast Set Waterproof Elastomeric Spray | Flexible 600%+ Elongation | 10-30 Second Set Time | 100% Solids
- Excellent elongation – 600%+
- Protects wide variety surfaces - concrete, metal, wood etc
- Chemical Resistant
- High Impact & Abrasion Resistance
- Application temperature range 20°F to 200°F
-
3246 Polyurea Flexible Expansion Joint Filler | Quick Cure | Exterior Interior | Low Temp -20°F | Elongation 600%+
- Quick set with "Drive-Over" in 30 to 45 minutes
- High Density Polyurea
- Very Flexible with Elongation ASTM D124 >600%
- Meets USDA Requirements for intermittent contact
- Meets FAA P605 – for airfield joints
-
E-Poly Pigment For All Floorguard Epoxy & Polyaspartic Coatings | 12 Colors
Starting at $52.00 -
E1015V Vertical Wall Epoxy Coating & Primer to 8 Mils No Sag | 11 Colo
- No sagging on vertical walls up to 8 mils per coat (4 mils DFT)
- Good for priming or coating concrete, wood or masonry.
- Good chemical and abrasion resistance
- Long 1 - 1.5 hour pot life
- Excellent adhesion 425 psi @elcometer
-
E1016 Anti-Slip Epoxy Concrete Floor Coating – 3 Gal Kit | 20 Colors | Tennis Court Like Surface
- Adds a slip resistant finish to concrete floors
- Good for use on surfaces subject to bare foot traffic
- Long 1 - 1.5 hour pot life
- Excellent adhesion
- Good chemical and abrasion resistance
-
E139FL Flexible Epoxy Primer & Floor Coating | 60% Elongation | 100% Solids | Indoor & Outdoor
- Exceptionally flexible epoxy with 60% elongation
- High Build up to 50 mils thick per coat
- 100% Solids Commercial Epoxy
- Excellent Adhesion 450 psi
- Tough Abrasion resistant Only 6 mg loss (Tabor test) and 160 inch lbs Gardner variable impact test
-
E144 Epoxy Primer & Base Coat | Concrete Wood metal | Satin Finish | Flexible | 20 Colors | Solvent Base | Low Temp 40F
- Commercial Grade Epoxy Primer & Coating
- Versatile Works on Concrete, Wood, Steel
- Helps reduce problems from concrete outgassing (air bubbles)
- Long POT Life 3+ hours Means Easy Dip and Roll Application
- Apply low temp to 40F
-
E322HW High-Gloss Aliphatic Urethane Abrasion & Chemical Resistant Low
- Outstanding durability with impact resistance of 160 in lb (Gardner Impact test)
- Excellent abrasion resistance Only 22 mg loss (Tabor Abrasion test) Reduced to 10 mg loss using our High Wear 325 additive
- Cold temperature application down to 45F
- Excellent Chemical Resistance
- Aliphatic, UV Stable and will not yellow