Product Description

800 Slow Set Polyurea Sealant Adhesive & Caulk

APPLICATION INSTRUCTIONS

Application

The product is mixed and applied via a 1:1 duplex cartridge or a plural component 1:1 ratio pump fitted with the proper static mixer.

Surface Preparation

Surface is to be free of all contaminants that would act as a bond breaker. The area to be sealed should be sound to the degree that good bonding of the sealer will result when properly applied.

Concrete

All surfaces must be dry and dust free.

Curing Time:

Back in service time –traffic- 1 to 1.5 hours approximately. Re-coat 30 minutes to 45 minutes @ 70°F. Full cure in 6 to 8 hours @ 70°F. Concrete: Must be cured at least 28 days.All surfaces must be dry and dust free.

Limitations
The product set time is temperature dependent, i.e., warm or hot conditions will speed the set time and cool conditions will slow the set time. Do not use on wet surfaces or expose part A to moisture. Keep out of direct sunlight, store at room temperature. Always shake part B before using. Do not allow the product to stand in the static mixer. Use at 5 degrees F above dew point. Keep cartridges warm when using product in cool conditions.

Do not use on wet surfaces or expose part A to moisture. Keep out of direct sunlight,store at room temperature.Do not allow the product to stand in the static mixer. Use at 5 degrees F above dew point. Keep cartridges warm when using product in cool conditions.

Do not expose boxes of cartridges to sunlight or store in
hot areas as this will accelerate gel time. Important:Hot conditions will speed the set time of the product, while cool conditions will slow the set time.

NOTICE TO BUYER: DISCLAIMER OF WARRANTIES AND LIMITATIONS ON OUR LIABILITY We warrant that our products are manufactured to strict quality assurance specifications and that the information supplied by us is accurate to the best of our knowledge. Such information supplied about our products is not a representation or a warranty. It is supplied on the condition that you shall make your own tests to determine the suitability of our product for your particular purpose. Any use or application other than recommended herein is the sole responsibility of the user. Listed physical properties are typical and should not be construed as specifications. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, REGARDING SUCH OTHER INFORMATION, THE DATA ON WHICH IT IS BASED, OR THE RESULTS YOU WILL OBTAIN FROM ITS USE. N0 WARRANTY IS MADE, EXPRESSED OR IMPLIED, THAT OUR PRODUCT SHALL BE MERCHANTABLE OR THAT OUR PRODUCT SHALL BE FIT FOR ANY PARTICULAR PURPOSE. NO WARRANTY IS MADE THAT THE USE OF SUCH INFORMATION OR OUR PRODUCT WILL NOT INFRINGE UPON ANY PATENT. We shall have no liability for incidental or consequential damages, direct or indirect. Our liability is limited to the net selling price of our product or the replacement of our product, at our option. Acceptance of delivery of our product means that you have accepted the terms of this warranty whether or not purchase orders or other documents state terms that vary from this warranty. No representative is authorized to make any representation or warranty or assume any other liability on our behalf with any sale of our products. Our products contain chemicals that may CAUSE SERIOUS PHYSICAL INJURY. BEFORE USING, READ THE MATERIAL SAFETY DATA SHEET AND FOLLOW ALL PRECAUTIONS TO PREVENT BODILY HARM.