GT 6895 High Solids Silicone Roof Coating – High Build

COVERAGE RATE

MIXING AND APPLICATION INSTRUCTIONS

Surface Prep: All surfaces to be coated must  be clean and dry; chemical cleaners, power-washing and/or priming the surface may be necessary to ensure optimal adhesion for some substrates. Any damaged membranes, flashings nad penetration points must be properly reparied and sealed prior to application. Low water ponding areas should also be repaired to avoid future water ponding.

Mixing: Mix well before using until a uniform consistency and color is achieved. A power mixer is recommended for quantities larger than one gallon

Thinning: DO NOT THIN. The addition of thinners or other additives will alter the intended performance and void all warranties.

Weather Restrictions: It is recommended nto to apply in temperatures less than 40 degrees Fahrenheit; do not apply if rain is expected within four hours of application. If applied in lower temperatures, the cure time may be affected.

Application Equipment: This product may be sprayed, brushed or rolled.

Cure Time: The coating can dry in 1-4 hours depeneing on variables such as temperature and humidity. A subsequent coat should be appleid as soon as the previous one can safely be walked on.

Clean Up: All equipment can be cleaned using 100% mineral spirits. Do not use water or reclaimed solvents.

Storage: Open Containers: Once the material is open, the curing process has begun and the entire container should be used. Allow leftover material to solidify and dispose of according to local and state regulations.

Caution! Roof surfaces may become slipper when wet

Storage & Handling

For best results use within two (2) years of date of manufacture; store in unopened containers between 40 – 85F

Packaging: GT 6895is available in 5  gallon pails

Safety: Please refer Safety Data Sheet for complete safety and regulatory information.

The information, data, and suggestions contained herein are believed to be reliable, based upon our knowledge and experience; however, it is expressly declared
that Seller does not guarantee the result to be obtained in Buyers’ process. SELLER HEREBY EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTABILITY
FOR FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED as to any and all products and/or suggestions described
herein, whether such products are used alone or in combination with other materials. Buyer must make its own determination of the suitability of a product for
its use, and the completeness of any information contained herein. Nothing contained herein shall be construed to constitute inducement or recommendation
to practice any invention covered by any patent without authority from the owner of the patent. Applicator is an independent contractor of, and should under no
circumstances be viewed as an employee or agent of GT Products, Inc. or GT Products subsidiaries.