EXPERT Clean & Bright Eco Cleaner | Multi-Purpose Wood Cleaner & Stain Remover| Environmentally Friendly | Removes Organic Growth | Oxygenated Wood Bleach

COVERAGE RATE

4oz to 8oz of EXPERT Clean & Bright Eco Cleaner will make 1 gallon of cleaning solution after adding water and cover approximately 150 to 250 sq. ft. depending on surface and method of application.

APPLICATION INSTRUCTIONS FOLLOW THESE SIMPLE APPLICATION STEPS:  Easy-to-Use & Clean-Up.

Read through all the step-by-step instructions prior to using EXPERT®™ Clean & Bright Eco Cleaner.

MIXING: Always wear heavy-duty rubber gloves, niosh approved respirator and PPE when working with EXPERT Clean & Bright Eco Cleaner, or any other EXPERT Clean & Bright products.

Mix 4oz to 8oz of Eco Cleaner with each gallon of warm water and stir thoroughly until powder is mostly dissolved. For larger projects 8 pounds of powder in a 1 gallon container makes 16 gallons of liquid cleaner.  Mix in a separate 5-gallon pail before transferring into a pump sprayer. This avoids clogging the sprayer. Use Cleaner solution within 4 hours of mixing.  Eco Cleaner mixed solution is Green in color for ease of identification.

APPLICATION: Pre wet the surface with water before application. Apply EXPERT Clean & Bright Eco Cleaner solution with a sprayer, brush, or car wash brush, working on small areas (100-200 sq. ft.) at a time.

If applying cleaner on vertical surfaces using a sprayer, work on small areas at a time, starting at the bottom, and working your way up.

If needed, scrub thoroughly with a hard, short, bristled broom, or brush. Be sure to keep the area wet with additional solution or mist from a water hose and allow the eco cleaner to sit for approximately 5 to 20 minutes or until the desired result is achieved.

RINSE: Rinse thoroughly with water from a hose or pressure washer using lowest effective pressure, to clean without damaging the wood.  For extreme build up of dirt, or organic growth use either a power washer, or a hard bristled brush. While using a power washer, use only the minimum effective amount of pressure to achieve the desired result.  Particular care should be taken in order to not damage the wood, power wash using a pendulum motion the full length of each board.  Do not start and stop as scarring or gouging of wood can occur.

NEUTRALIZE: After cleaning is complete, immediately neutralize and brighten the wood using EXPERT Clean & Bright Wood Brightener. Let EXPERT Wood Brightener sit for 5 to 15 minutes ensuring the entire surface has been properly neutralized and rinsed thoroughly. A color change will be evident when properly brightened, this will open wood grain and prevent poor stain penetration.

IMPORTANT: After Brightener is applied, rinse wood’s entire surface for 10 to 15 minutes, and rinse all nearby surfaces including siding, windows, and foliage.

Allow wood surfaces to dry 48 to 72 hours (or longer) before applying EXPERT Stain & Seal wood stains. Stains must be applied when wood is dried to 13% moisture content or less.

Clean-up: Clean tools and equipment immediately after each use with soap and water.

WARNING

• Keep out of reach of children. Exposure to sodium metasilicate could cause irritation to the eyes, skin, or lungs.
• If contact occurs, rinse immediately with water for 15 minutes. If irritation continues, seek immediate medical attention.
• Do not ingest.
• Always wear personal protective equipment when using this product.
• DO NOT MIX WITH OTHER CHEMICALS.

NOTICE TO BUYER: DISCLAIMER OF WARRANTIES AND LIMITATIONS ON OUR LIABILITY We warrant that our products are manufactured to strict quality assurance specifications and that the information supplied by us is accurate to the best of our knowledge. Such information supplied about our products is not a representation or a warranty. It is supplied on the condition that you shall make your own tests to determine the suitability of our product for your particular purpose. Any use or application other than recommended herein is the sole responsibility of the user. Listed physical properties are typical and should not be construed as specifications. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, REGARDING SUCH OTHER INFORMATION, THE DATA ON WHICH IT IS BASED, OR THE RESULTS YOU WILL OBTAIN FROM ITS USE. N0 WARRANTY IS MADE, EXPRESSED OR IMPLIED, THAT OUR PRODUCT SHALL BE MERCHANTABLE OR THAT OUR PRODUCT SHALL BE FIT FOR ANY PARTICULAR PURPOSE. NO WARRANTY IS MADE THAT THE USE OF SUCH INFORMATION OR OUR PRODUCT WILL NOT INFRINGE UPON ANY PATENT. We shall have no liability for incidental or consequential damages, direct or indirect. Our liability is limited to the net selling price of our product or the replacement of our product, at our option. Acceptance of delivery of our product means that you have accepted the terms of this warranty whether or not purchase orders or other documents state terms that vary from this warranty. No representative is authorized to make any representation or warranty or assume any other liability on our behalf with any sale of our products. Our products contain chemicals that may CAUSE SERIOUS PHYSICAL INJURY. BEFORE USING, READ THE MATERIAL SAFETY DATA SHEET AND FOLLOW ALL PRECAUTIONS TO PREVENT BODILY HARM.