Mend-Con RTU Concrete Repair | Apply Underwater | Vertical No Sag | Quick Cure | Paintable | Low Temp 40˚F | Case of 12

MIXING AND APPLICATION INSTRUCTIONS

PRODUCT STORAGE: Store product in an area so as to bring the material to normal room temperature before using. Continuous storage should be between 50 and 90 degree F. Keep from freezing.

SURFACE PREPARATION:

Surfaces to be bonded should be sound and cleaned so there is no dust, dirt, grease, wax, oil or any other contaminants present.
Smooth surfaces should be roughened with sandpaper or a wire brush before application.

DIRECTIONS FOR USE

• Unscrew plastic cap and remove plug from threaded end of cartridge.
• Place cartridge into a 10 oz caulking gun (Supplied with case of 12 cartridges)
• Dispense a small amount of adhesive into a disposable container until both materials flow from the cartridge.
• Attach mixing nozzle to cartridge and dispense a small amount of material into same disposable container until a consistent color with no streaks is obtained.
• Cartridge is fully dispensed when the plunger reaches half way.

BONDING AND PATCHING APPLICATIONS

• Apply an even coat of the mixed product to the clean and prepared surfaces. When bonding two surfaces together, make sure to fill all gaps between the mating surfaces.
• For patching concrete or wood surfaces, fill the void with the epoxy adhesive to just above the surface level and trowel flush.

LIGHT DUTY ANCHORING ONLY
NOTE: Do not use for overhead or sustained load anchoring.

• Dispense the material from the bottom of the hole. Fill approximately 2/3 of the hole depth while slowly withdrawing the nozzle.
• Insert the threaded rod or rebar to the bottom of the hole while turning clockwise. The threaded rod or rebar should be free of dirt, grease, oil or other foreign materials.  Do not disturb or secure bolt to threaded rod or rebar until initial cure time has passed (3 hours at 75°F).

CLEANUP:

RESTRICTIONS:  Always use safety glasses and chemical resistant gloves when handling materials.

LIMITATIONS

• Substrate temperature must be 5°F above dew point.
• Physical properties are typical values and not specifications.

NOTICE TO BUYER: DISCLAIMER OF WARRANTIES AND LIMITATIONS ON OUR LIABILITY We warrant that our products are manufactured to strict quality assurance specifications and that the information supplied by us is accurate to the best of our knowledge. Such information supplied about our products is not a representation or a warranty. It is supplied on the condition that you shall make your own tests to determine the suitability of our product for your particular purpose. Any use or application other than recommended herein is the sole responsibility of the user. Listed physical properties are typical and should not be construed as specifications. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, REGARDING SUCH OTHER INFORMATION, THE DATA ON WHICH IT IS BASED, OR THE RESULTS YOU WILL OBTAIN FROM ITS USE. N0 WARRANTY IS MADE, EXPRESSED OR IMPLIED, THAT OUR PRODUCT SHALL BE MERCHANTABLE OR THAT OUR PRODUCT SHALL BE FIT FOR ANY PARTICULAR PURPOSE. NO WARRANTY IS MADE THAT THE USE OF SUCH INFORMATION OR OUR PRODUCT WILL NOT INFRINGE UPON ANY PATENT. We shall have no liability for incidental or consequential damages, direct or indirect. Our liability is limited to the net selling price of our product or the replacement of our product, at our option. Acceptance of delivery of our product means that you have accepted the terms of this warranty whether or not purchase orders or other documents state terms that vary from this warranty. No representative is authorized to make any representation or warranty or assume any other liability on our behalf with any sale of our products. Our products contain chemicals that may CAUSE SERIOUS PHYSICAL INJURY. BEFORE USING, READ THE MATERIAL SAFETY DATA SHEET AND FOLLOW ALL PRECAUTIONS TO PREVENT BODILY HARM.